VetScan i-STAT 1 Analyser
Installation Guide
Step 1: Unpacking
- Remove the VetScan i-STAT 1 Analyser from the shipping carton.
- Check the components received with the VetScan i-STAT 1 Analyser against the following list to ensure you have everything required to set up the analyser:
- If you ordered the VetScan i-STAT 1 Starter Kit
- VetScan i-STAT 1 Analyser
- Two 9-volt lithium batteries
- VetScan i-STAT User Guide
- VetScan i-STAT technical bulletin packet
- VetScan i-STAT operator’s manual
- Martel printer
- VetScan i-STAT 1 serial downloader
- If you ordered only the VetScan i-STAT 1 Analyser:
- VetScan i-STAT 1 Analyser
- Two 9-volt lithium batteries
- VetScan i-STAT User Guide
- If you ordered the VetScan i-STAT 1 Starter Kit
Step 2: Install/Change Batteries
- Slide the battery compartment door off.
- Tilt the analyser to slide out the battery carrier.
- Locate two (2) 9 volt lithium batteries. Insert a battery into each side of battery carrier, matching + and – marks on batteries to the + and – marks on battery carrier.
- Slide battery carrier into the analyser (Label facing up).
- Slide battery door back into place.
Step 3: Check/Change Date and Time
- Turn on analyser
- Press Menu to change screen to Administration Menu.
- Press 5 (Set Clock)
- Press Ent (No password is required)
- Use arrow keys to move the cursor to a digit if it needs to be changed. Use number keys to change digit.
- Press Ent to accept changes, or Menu to cancel changes.
Step 4: Check Software and Status
- From the Administration Menu, press 1.
- Check that software (CLEW & Version) in the Analyser is up to date.
